Skip to main content
Skip table of contents

Legal Information

EU Declaration of Conformity

i3-TECHNOLOGIES NV declares that this Declaration of Conformity is issued under our sole responsibility, and that this product, i3TOUCH ES - Interactive Flat Panel Display, complies with all Essential Requirements of the Directives, specifically the relevant Union harmonization legislations: 2014/30/EU Electromagnetic Compatibility Directive, 2014/35/EU Low Voltage Directive, and 2011/65/EU Restriction of Hazardous Substances in Electrical and Electronic Products.

This product carries the CE mark, which was first affixed in 2020.

FCC Declaration of Conformity

i3-TECHNOLOGIES NV declares that this Declaration of Conformity is issued under our sole responsibility, and that this product, i3TOUCH ES - Interactive Flat Panel Display, has been tested and found in compliance with the requirements of 47 CRF Part 15 regulations and ANSI C63.4 for the verification of Class B of electromagnetic compatibility.

FCC Warning

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and

  2. this device must accept any interference received, including interference that may cause undesired operation.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 

  • Reorient or relocate the receiving antenna.

  • Increase the separation between the equipment and receiver. 

  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

  • Consult the dealer or an experienced radio/TV technician for help. 

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.